Hang Your Skateboard On The Wall

Get your skateboard and slip the rope over the wheels to hang your skateboard.

Hang your skateboard on the wall. The knots may loosen or the rope. After that use the screwdriver to secure the knots with the screws. For wooden walls you will just need to drive the screws into the wall with a screwdriver. Instead of hammering a nail into the wall after you ve tied a knot in the fishing line use a pencil to draw a horizontal line on the wall that s level with the floor where you d like your skateboard to be hung.

Installation is easy and cheap. Once the rope is fixed at both ends slide your deck inside and the wheels will grip the rope to hang perfectly. If your wall is a brick wall before screwing the knots you need to drill the holes by using the masonry bit and then add the wall plugs. It is into this wall plugs that you will then secure the knots with screws using the screwdriver.

Finally a well thought skateboard display. How to hang a skateboard on the wall. Now you have it a strong rope on the wall to hang your skateboard on. Whether you are retiring an old deck or wanting to highlight a limited edition graphic hanging a skateboard is a project that will take about half an hour and can.

The final step is dependent on the type of wall. With this you are good to go. Like the founders of tigerclaw we were regularly confronted with the problem of hanging our skateboards on a wall. Besides being a pastime for teens and adults for decades skateboards can be displayed on your wall as works of art.

The guys at sk8ology sent me some of their products the other day to try out and i was impressed. That s it to hang your skateboard just slip the rope over the wheels. To hang your most beautiful skateboards in your flat here is a part you should not skimp. You can hang the same skateboard that you use regularly.

If you intend to use the skateboard as a decoration object we have found the claw you need. Once both the knots are screwed to the wall hang your skateboard with the lower side on the top. Sk8ology skateboard display kit tube no drill bit. If your wall is a wood wall you can just screw directly into it.

If the wall is made of wood screw directly into the wall or drill a small pilot hole first. If it s a brick wall drill a hole using a masonry bit and add a wall plug before screwing each knot into place using a screw and screwdriver.