Hanging Framed Art On Plaster Walls

Hanging things on plaster walls is easy if you have a drill and screws.

Hanging framed art on plaster walls. Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail. As mentioned earlier avoid using nails on plaster wall because they will likely cause the drywall to crack. Using the right hardware for hanging art combined with the correct installation. To hang really heavy pictures on plaster walls use a toggle bolt by drilling a hole in the wall pushing the bolt s wings into the hole and tightening the screw.

To hang a picture on a plaster wall make a pencil mark where you want to hang the picture then cover the mark with a small piece of painter s tape. Hold the picture against the wall at the height you want it to hang. Hanging art on drywall is fairly straightforward. Mark the spot on the wall above the center of the frame.

Plaster walls tend to crack or crumble easily so hanging art is a special challenge for this type of surface. Instead use a screw because they won t break the plaster wall. For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done. Plaster hooks or hanging picture hooks are a common solution for hanging pictures on plaster wall.

Make sure you leave half an inch out of the wall so you have space to hang your artwork. Lay the picture frame face down on a table and place a strip of painters tape or masking tape across the frame just above the eyelet screws. All you need to do is pre drill a hole slightly narrower than your screws then use the drill to drive a screw into the hole. In today s video i run through the best options for hanging a heavy picture on a plasterboard wall.

Because plaster is a much harder surface you likely won t be able to push the pin through. Place a hook on the rail directly above the center mark. If you love my content and would like to send me a couple. Then hammer a wall anchor into the hole until it s flush with the plaster.

They can generally support pictures of up to 20 pounds. Next drill a hole into the mark using a 3 16 drill bit before removing the piece of tape. If you re not sure whether your walls are drywall or plaster try pushing a pin or thumbtack into the wall. If it goes through you re dealing with drywall.